This page is more for my personal reference trying to keep track of what settings I needed to print each of the filaments I have. Over time its been a bit much to keep track of them all as my collection grows so a nice chart was in order. These are the settings that worked for me and my printer setup. They likely won’t correlate exactly so your setup but may give you an idea of where to start. My setup is a Creality Ender 3 Pro with Sprite Pro direct mount extruder and PEI bed sheet. Only modifications to Cura’s defaults are specific to the Sprite Pro extruder where I set retraction to 0.8 mm and retraction speed at 45mm/s
Calibration cubes are using setting modifications listed in the chart.